Lift and remove the I/O board data cable from the MacBook Pro. Gently twist the spudger to disconnect the I/O board data cable connector from its socket on the Wedge the flat end of a spudger beneath the left side of the I/O board data cable connector. Prying the socket may cause irreversible damage to the I/O board. When prying the I/O board data cable connector from its socket, make sure to pry the connector Use the flat end of a spudger to pry the right side of the I/O board data cable connector up off its socket on the I/O board. If you have neverĪpplied thermal paste before, we have a guide that makes it easy. When reinstalling the heat sink, be sure to apply a new layer of thermal paste. Lift and remove the heat sink up off the logic board assembly. Remove the following screws securing the heat sink to the logic board assembly: One 2.4 mm Phillips #00 screw One 3.4 mm T5 Torx screw Four 2.7 mm T5 Torx screws
It's also a good idea to take it out so it doesn't fall out unexpectedly. Preventing your computer from accidentally powering on. Removing this board will ensure that the battery remains disconnected throughout your repair, Lift the Interposer off the logic board and remove it. Repair, it is the board connecting the battery to logic board. It is recommended to bend the battery cables just slightly, to keep the board suspended up above the logic board and out of the way.ĭo not fold the board completely over, or crease the cables, as this may damage the battery.Īn interposer is the name for an interface that links one electrical connection to another. Remove the wide head 6.4 mm T6 Torx screw securing the battery connector to the logic board assembly.Ĭarefully lift the battery connector board up off the logic board. Use tweezers to remove the small plastic cover located near the bottom right of the battery connector board. Remove the following screws securing the battery connector board to the logic board: Two 2.8 mm T6 Torx screws One 7.0 mm T6 Torx shouldered screw Remove the plastic cover adhered to the battery contact board. The lower case is connected to the upper case at the center, with two plastic clips. Gently pull the lower case away from the upper case.ĭuring reassembly, gently push down the center of the lower case to reattach the two plastic clips. Wedge your fingers between the upper case and the lower case. Remove the following ten screws securing the lower case to the upper case: Two 2.3 mm P5 Pentalobe screws Eight 3.0 mm P5 Pentalobe screwsĮach screw and make sure it goes back exactly where it came from to avoid damaging your device. MacBook Pro 13" Retina (Late 2012 Early 2013) Screw Set (1) MacBook Pro 13" Retina (Late 2012) 2.9 GHz Logic Board (1) MacBook Pro 13" Retina 2.5 GHz Logic Board (1)
Phillips #00 Screwdriver (1) iFixit Opening Tools (1) Spudger (1) T5 Torx Screwdriver (1) T6 Torx Screwdriver (1) Tweezers (1) MacBook Pro and Air 5-Point Pentalobe Screwdriver (1) Use this guide to replace the logic board. This document was generated on 04:45:45 PM (MST).
Replace the Logic Board in your MacBook Pro 13" Retina Display Late 2012. MacBook Pro 13" Retina Display Late 2012 Logic Board Replacement
File Info : application/pdf, 22 Pages, 7.63MB Document Document guide 13146 en MacBook Pro 13" Retina Display Late 20.
0 kommentar(er)
